Find Your Product Instructions
-
Internal Hub Motors
- Internal Hub Kit Installation
- Internal Hub Kit FAQs
- Troubleshooting Internal Hub Kits
- Internal Vector Controller Wiring and Parts
- Programming Internal Controller With USB Cable
- Smart Display and Bluetooth Instructions
- Adding Lights and Horn
- How to Replace the Vector Internal Controller
- Electric Drift Trike Installation
- Dual Hub Motor Setup
- Dual Hub Motor Setup with Cycle Analyst v3
- Magic/Smart Pie 3 and 4 Information
- Spoking a Hub Motor Wheel
-
External Hub Motors
-
Bafang Mid-Drive
- Bafang Mid-Drive Installation
- Troubleshooting Bafang
- Selecting the Right Bafang Motor
- Bafang Installation Improvements
- Bafang Shift/Gear Sensor Install
- Flashing the Bafang Controller (Error 07/30)
- Programming Your Bafang Controller
- Bafang Display Guides
- EggRider Display
- Bafang Chainline and Q-Factor
-
BLDC Motors
-
Cycle Analyst
-
CYC Motor
-
Basic Installation
-
Miscellaneous
< All Topics
Programming External Controller
Updated
How to Program the External Magic Controller
The External Magic Controller can be programmed using this USB Programming Cable with the software below. Note that the battery should be OFF or disconnected when programming.
External Controller Programming Software
Table of Contents