Bafang Mid-Drive

Bafang Chainline and Q-Factor

Bafang Chainline Issue For all our chainrings, spacers, and cranks, click here. Bafang Q-Factor Problem For an ideal Q-Factor on the Bafang kit: Lekkie Buzz Bars – Left Offset 160mm V3.1 Lekkie Buzz Bars – Left Offset 170mm V3.1

Read more

EggRider Display

How to Activate The EggRider: To activate the EggRider please enter the following information: Shop name: Golden MotorOrder number: Written on the EggRider box that you received Within 24 hours you will get an email from EggRider with the activation...

Read more

Bafang Display Guides

850C/DPC-14 Display: DPC-18 Display: C961 Display: C965 Display: 500C Display: EggRider Display: For the EggRider complete guide, check out this article.

Read more

Programming Your Bafang Controller

How to Program Your Bafang Controller To program your controller, first you need to flash it with the correct unlocked (.bin) firmware. Check out this article for more details. Once your controller is unlocked, you can either program it using the USB...

Read more

Flashing the Bafang Controller (Error 07/30)

How to Flash your Bafang Controller Error 30 is a communication fault, and can be solved by flashing the controller. Error 07 is an over-voltage error. If you are using a 52V battery and your controller has a 48V firmware,...

Read more

Bafang Shift/Gear Sensor Install

How to Install the Bafang Shift/Gear Sensor This is an additional sensor that cuts power to the motor when you are shifting gears on your bike. The sensor goes over the shifter cable, on either the front or the rear....

Read more

Bafang Installation Improvements

Motor is Loose After using the Bafang motor for a while, it tends to get loose. Here are two products that keep the motor tight on the bottom bracket: Lekkie Onenut Bafang Stabilizer Bar   For the full Lekkie OneNut...

Read more

Selecting the Right Bafang Motor

The Right Bafang Motor for Your Bottom Bracket Bottom Bracket Width: 68mm or 73mm: You will need the 68mm Bafang motor (with the option of 73mm BB screws) Under 100mm: You will need the 100mm Bafang motor (with the option of BB...

Read more

Troubleshooting Bafang

Display is on but throttle isn’t working: Unplug your e-brakes and shift/gear sensor and then try to use the throttle. If it works, then plug each e-brake and sensor one at a time to determine which one is causing the...

Read more