High Powered Cycle Analyst v2 Installation
How to Install the High-Powered Cycle Analyst v2 This is the wiring diagram and instructions for the High-Powered Cycle Analyst v2. Connect one side of shunt to the negative terminal of the battery and the other side of the shunt...
Dual Hub Motor Setup with Cycle Analyst v3
Running Two Motors with a Cycle Analyst v3 To power two hub motors with the same throttle, you will need two motors and two controllers, and you can hook them all up together using a cycle analyst and a dual...
Detailed Cycle Analyst v3 Display Screens and Operation
This video goes over all the cycle analyst display screens, operation, and settings:
Cycle Analyst v3 Installation and Configuration
How to Install the Cycle Analyst v3 with Shunt and Configure PAS The Cycle Analyst v3 with Shunt is a universal display that can be wired to any e-bike for detailed electrical information and highly configurable PAS. This video explains the general...
Programming EZkontrol Controller
To program your EZkontrol controller, all you need is your Bluetooth smartphone. There is no USB programming option. You can program with an iOS or Android device, but the process differs slightly. The instructions below and the video at the...
EZkontrol Communication Protocols
CAN Protocol Instructions and Specifications The documents below can be used as a guide for CAN communication with the EZkontrol motor controllers. Please note that this type of communication with the controller is advanced and not required. Programming can be done via...
EZkontrol Wiring with BLDC Motor
EZkontrol Wiring Diagrams The user guide below contains wiring diagrams for the EZkontrol motor controller with and without a DC contactor (pages 6-7). Since this is a universal motor controller, you can wire this controller to any BLDC motor. You...
Sailboat Build With BLDC Motor
Customer Sailboat Conversion Build With BLDC Motor For the conversion project, a 48V 10kW BLDC Motor, a Vector 500 Controller, and a Joystick Throttle are used. Connecting and Programming Joystick Throttle To get started with PI-800 programming, check out this article....
Programming Large Vector Controller
Programming Using a USB Programming Cable To do this, you will need a Windows computer and a USB programming cable. Keep your battery OFF or disconnected while programming. Download and open the following programming software (PI-800):https://www.goldenmotor.com/controllers/PI-800.rar Connect the USB programming...