Internal Hub Motors
Dual Hub Motor Setup with Cycle Analyst v3
Running Two Motors with a Cycle Analyst v3 To power two hub motors with the same throttle, you will need two motors and two controllers, and you can hook them all up together using a cycle analyst and a dual...
How to Spoke/Lace a Wheel We sell motor-specific spokes and spoke wrenches on our store. The links can be found at the bottom of this article. Replacing a Broken Spoke Spokes can break if they are over-stressed or haven’t been...
Magic/Smart Pie 3 and 4 Information
Hub Motor Version Golden Motor has several different hub motor versions that all come with internal controllers. Go to “Additional FAQs” for help in identifying which motor version you have. If you have one of the hub motors that use...
How to run two hub motors with one throttle
This video goes over the process of adding two hub motors to a bicycle and controlling them with one throttle.
Electric Drift Trike Installation
How to convert a Triad Drift Trike to electric The video below goes over the process of converting a triad drift trike. These things are super fun! Take a look at the video description to find our product listings so...
How to Replace the Vector Internal Controller
Removing the Internal Vector Controller Unscrew the 6 screws on the edges of the controller. Carefully unplug the three coloured phase wires Unplug the 6-pin hall sensor plug. Make sure to push on the little tab so that it comes...
How to add a light and/or horn to your internal hub kit (Magic Pie 3, 4, 5) On the wiring harness for the throttle, brakes, etc. there is an unterminated cable (a wire without a proper plug/connector). You need to...
Smart Display and Bluetooth Instructions
Smart Display All information regarding the Smart Display (BAC-601) can be found in the User Guide below. Smart Display (BAC-601) User Guide Bluetooth + Smartphone Display This video goes over the process of connecting your smartphone to your Bluetooth dongle....
Programming Internal Controller With USB Cable
Programming Using a USB Programming Cable To do this, you will need a Windows computer and a USB Programming Cable. Download and open the following programming software (PI-800):https://www.goldenmotor.com/controllers/PI-800.rar Connect the USB programming cable to the display/bluetooth 5-pin plug on the motor...