Free Shipping on Orders $500 to US & Canada *Exclusions apply

Product Description

The Heavy Hitter 420 Primary Chain Drive Conversion Kit swaps the stock primary belt for a 420 chain on the Sur Ron LBX, E Ride Pro, Ventus One Plus and 79Bike Falcon. Upgraded motors and controllers push a stock belt past its limit, and a belt that lets go mid-ride ends the day. This kit puts that power through steel and billet aluminum instead. You get a 30 tooth rear sprocket, a 13 tooth front sprocket and a 420 chain with a master link.

Fitment:

  • Sur Ron LBX / S 2017 to 2025
  • Segway X260
  • E Ride Pro S / SS / 2.0

Below Models: Front Sprocket Surron Side Outwards

  • E Ride Pro 3.0 / 4.0 / SR

Below Models: Non-Spline Shaft Motors

  • Ventus One Plus
  • 79Bike Falcon Pro / GT

NOTE: EBMX XLB motors must be shimmed, and the chain must run loose

There are no rubber dampers in this drive. That means no efficiency loss, no extra heat and no ledge for debris to pack into. The stock gear ratio and motor alignment stay the same, so the bike pulls the way it was geared.

The rear is 7075-T6 billet and the front is nitrided 52100 tool steel, wrapped in a Japanese non-O-ring chain. All in, it weighs 1.37 lb, the lightest 420 primary setup on the market.

The front sprocket goes on a set way round for each bike: Surron #1 face out on the Sur Ron LBX and on the E Ride Pro 3.0, 4.0 and SR, E-Ride #2 face out on the E Ride Pro S and SS. Reuse your stock bolts on the 30 tooth; they are not in the box. The tech sheet covers assembly and torque, and the primary drive guide covers setup.

It is louder than a belt. Every chain drive is, and this one is no louder than the rest.

Download Tech Sheet (Assembly & Torque Specs)

Detailed Specs