Sailboat Build With BLDC Motor
Customer Sailboat Conversion Build With BLDC Motor For the conversion project, a 48V 10kW BLDC Motor, a Vector 500 Controller, and a Joystick Throttle are used. Connecting and Programming Joystick Throttle To get started with PI-800 programming, check out this article....
Programming Large Vector Controller
Programming Using a USB Programming Cable To do this, you will need a Windows computer and a USB programming cable. Keep your battery OFF or disconnected while programming. Download and open the following programming software (PI-800):https://www.goldenmotor.com/controllers/PI-800.rar Connect the USB programming...
Troubleshooting BLDC Motor / Vector Controller
Common Issues: The e-lock must be connected to the B+ pole and a switch needs to be attached to power the controller on and off or at minimum a paperclip inserted to close the circuit and power up the controller....
Can I permanently switch the default/primary rotation direction of the motor? Yes, you can! This forum post describes how to change the default direction of the BLDC motor. https://goldenmotor.com/SMF/index.php?topic=6929.msg37790#msg37790 Shorting the reverse plug on the controller will temporarily change the...
BLDC Motor + Vector Controller Wiring
How to Wire The Large Vector Controller and BLDC Motor Below is the wiring diagram for the 3kW and 5kW BLDC motors with the Vector Controller (with and without contactor). At the 9-minute mark, this video goes over all the...