Rear Hand Brake Line | Steel Braided | Surron Ultra Bee, Light Bee, Talaria, Eride Pro

Steel Braided Rear Hand Brake Line for Surron, Talaria & Eride Pro Moto Brakes

Stop fighting a spongy, flexy stock line. This custom-built rear hand brake line swaps in stainless-steel braid over a PTFE inner core, so every bit of lever input goes straight to the caliper - no flex, no fade, no sponge feel, even after hard laps and big jumps.

Built to Perform:

• PTFE inner core for smooth, consistent fluid flow under pressure
• Stainless steel braided mesh for zero-expansion strength - firmer lever feel than stock rubber lines
• Clear PVC outer layer protects the braid from dirt, moisture, and abrasion
• 90° banjo at the master cylinder, 28° banjo at the caliper - positioned so the line never rubs or binds against swingarm travel, even at full suspension extension
• Custom length, cut and finished to fit your Emoto perfectly - no trimming or re-crimping needed

Fits These Models:

• Surron Ultra Bee (OEM Brakes & Big Brake Kit)
• Surron Light Bee (Moto Brake Only)
• Talaria X3 / MX3 / MX4 / MX5 (Moto Brake Only)
• Eride Pro S / Pro SS 1.0 / 2.0 / 3.0 / SR (Moto Brake Only)

Select your bike model above to get the correct fitment.

Simple Bolt-On Install

Pre-fitted banjo ends mean this is a straightforward swap - no custom crimping, no guesswork. Bolt it up, bleed the system, and get back to riding with a brake lever that finally feels like it should.

Ships Fast from the USA